ECI Tool Belt Training: Plan Reading, and FOG Removal Devices - On Demand
Recorded On: 09/01/2022
-
You must log in to register
- Non-member - $70
- Member - $50
CWEA Members: $50.00
Non-Members: $70.00
2.4 contact hours towards CWEA's ECI certification.
ECI Tool Belt Training: Plan Reading, and FOG Removal Devices
This special joint meeting. Contact hours for CWEA ECI certificate holders is available to members only.
Presentation Schedule:
P3S Committee Updates - William Edwards, Chair, City of Vacaville
Plan Drawing Examples for Source Control/Pollution Prevention by Linda Leong, PE
An Alternative Grease Removal Device for Fats+Oils+Grease+Solids by Dennis Doherty of The Filta Group
Q&A
Photo by Adobe stock.
William Edwards (Moderator)
Environmental Compliance Inspector
City of Vacaville
William Edwards is an Environmental Compliance Inspector for the City of Vacaville, working in FOG control, industry user compliance, storm water, and public outreach. With over ten years of combined inspection, water quality and laboratory experience, William holds one professional value above any other: A positive attitude. Before graduation from Long Beach State, William grew up in San Diego, where he developed a passion for the environment. His ongoing goal, is to inform the residents of the city that he serves, about the importance of pretreatment, pollution prevention, and storm water concerns.
Linda Leong
Senior Engineer
SFPUC
Ms. Linda Leong is a Process Engineer with SFPUC and has been an active member of CWEA, SF Bay Section, Professional Development Committee since 2000. She has an M.S. in Environmental Engineering, a B.S. in Chemical Engineering and Materials Science. She is registered as a Civil Engineer in California and has served on the NFPA Technical Committee "Wastewater Treatment Plants" since April 2006. Linda's approach to “seek first to understand” is a primary reason that she is considered a key “go to” person in her organization.
Dennis Doherty
Technical Director - FOGS Products
The Filta Group
Dennis Doherty from Los Angeles is the Technical Director for the Filta Group FOGS Products. Responsible for all aspects of the company's AGRD Automatic Grease Removal Device offerings for the USA and Canada. A longtime CWEA member (now all sections) and onetime LABS director, Dennis started in water and wastewater as a manufacturer's representative in 2006. He went solo with AGRD manufacturer GOSLYN in 2010 and was their exclusive distributor for the ten counties of So Cal until joining Filta in 2021. His approach has always been to serve both the end-users and authorities as a knowledgeable solution provider and problem solver for FOGS.
Registrants who view the live webinar to see the slides and hear the audio and then enter the correct attention check code (directions below) will receive 2.4 contact hours towards CWEA's ECI certification.
To receive your contact hours for viewing the live webinar, please note the two (2) different attention check codes that will be displayed at two different points during the webinar in the top left or right corner of the presentation for approximately 90 seconds. Please enter these codes as 1st attention check code – 2nd attention check code (XXXX-XXXX) in the Attention Check Code component under the "Contents" tab.
Please note, all user activity of CWEA certification holders on the Online Wastewater Education Network is subject to the CWEA Code of Ethics standards for professional conduct and ethics. Certification holders should receive credit for a training only once within the same contact hour period. Any attempt to undermine the certification process may be subject to ethics procedures and possible sanctions. It is not possible to receive contact hours for both attending the live webinar and viewing the recording.
Once you have entered the correct attendance check codes, you will be able to create and download an electronic certificate of completion under the "Contents" tab.
Key:
Complete
Next
Failed
Available
Locked
